Compression and torque spec sheet for your exact car
Factory numbers, sourced, on one printable page

About this service
Tell me year, trim, engine code and rough miles. You get a print-ready PDF built for that car: factory compression band, allowed spread between cylinders, leak-down bands, torque specs for plugs/drain/lugs with thread size and order, plug number and gap, and a blank four-cylinder log grid. Every line cites a source, single sources are labeled. One day turnaround. Wrong number? Tell me and I fix it.
Demo
Send me the year, trim, engine code and rough mileage. You get a print-ready PDF for that exact car: the factory compression band and the allowed spread between cylinders, leak-down bands, torque specs for spark plugs, drain plug and lug nuts (with thread size and order), the correct plug number and gap, and a blank log grid for four cylinders. Every line carries its source, and where I only have one source it says so on the page instead of pretending. Turnaround inside a day. If a number is wrong, tell me and I fix it.
COMPRESSION REFERENCE (excerpt) FA20DIT / 2015-2021 WRX: 196-254 psi (1350-1750 kPa), 200-300 rpm cranking, warm, throttle wide open. Allowed spread between cylinders: 14 psi absolute. Source: 2017 WRX owner quoting his factory service manual; one secondary source, labeled as such. K20Z3 / 2006-2011 Civic Si: 135 psi minimum at 250 rpm, WOT. Allowed spread: 28 psi absolute. Sources: 8thcivic Helm extract for 06-07 Si; 02-03 EP3 FSM agrees. PASS RULE: no cylinder below the factory minimum for that engine, and spread from best to worst no wider than the factory allowance. Percent of best is a sanity check for your eye, never the spec. A 10% rule passes cars the book flags and fails cars the book clears. READ IT RIGHT: even and low is usually fine. Altitude, a tired battery and a cold engine pull every cylinder down together. Uneven is the problem, not the absolute number. TORQUE (excerpt) FA20DIT spark plugs NGK ILKAR8H6 (96024), M12x1.25, 14 ft-lb dry, factory gap 0.020-0.022 in. K20Z3 spark plugs, M14x1.25, 13 ft-lb / 18 N-m. Oil drain, FA20/EJ25: 33 ft-lb with a new crush washer. Lug nuts: 2015-21 WRX 89 ft-lb; 06-11 Civic Si 80 ft-lb. Both M12x1.25, star order, dry, recheck at 50-100 miles.
