One piece of furniture, drawn to build
Dimensioned sheet: elevations, plan, joinery, cut list. Drawn by a woodworker.

Acerca del servicio
You send the idea and the numbers that actually matter: the space it has to fit, who uses it, the height and width you want, the wood you have on hand. I send back one dimensioned sheet: front and side elevations, a plan, joinery called out joint by joint, and a cut list with every part named and sized. Not a mood board. Not a render pretending to be a plan.
What I won't do: draw furniture that can't be made. If your numbers fight each other I'll say so, draw the version that works, and tell you what changed.
What I need from you: a photo, a sketch, or three sentences. If it has to sit next to something that already exists, say what.
What you get: a PNG sheet at print scale, plus the same spec in plain text so a bench can read it. One round of revisions included.
Time: 72 hours from a brief I can actually use.
Muestra
Demo: the spare chair. White oak side chair drawn from the offcut of a cafe counter slab, so it's the same tree as the room. One sheet, 2180x1340 px at 28 px per inch: front elevation, side elevation, seat plan, five joinery details, title block. Steam-bent back stiles, no metal anywhere.
Sample spec, the spare chair, white oak. Stile: one arc through three points measured from the seat top, back edge, in inches aft: A (0,0), B (2,8), C (6,16). R 39 3/8, center 39 aft and 5.5 below. Bending form: 3/4 in laminate, steam 45 minutes, clamp overnight. Slat centers 22 1/2, 27 and 31 1/2 in off the floor, 4 1/2 in on center, 2 in clear. Slat back edges land 7/8, 2 3/8 and 4 1/2 in aft of the seat back edge because the stile rakes. J1 leg to seat: 1/2 x 1 1/4 in tenon, 1/2 in deep. J2 stretcher to leg: 3/8 x 1 in tenon, 1 in deep. J3 slat to stile: housed 3/8 in deep. J4 stile to rear leg: bridle, 3/4 in slot, 1 1/4 in deep, two oak pins. J5 seat front: 1/4 in scoop, 3 in wide, stopped 2 in from the ends. Parts: legs 1 3/4 in square, tapered to 1 1/4 at the floor. Stretchers 1 x 1 1/4 in at 7 in off the floor. Seat 17 x 15.5 in, 1 in thick, 18 in high. Back stiles 3/4 x 1 3/4 in. Slats 2 1/2 wide, 3/8 thick. Finish: hardwax oil, nothing glossy. No metal in the piece.
Abrir muestra ↗Preguntas frecuentes
Do you design, or just draw?
Both, within one piece. Bring an idea and the numbers you care about and I shape it into something buildable. Bring a finished design and I make it legible to a shop.
What if I don't know my dimensions?
Tell me the room, the person and the job. I propose the numbers and tell you why each one is what it is.
Can you work from an existing piece?
Yes. Send a photo with one known measurement in frame and I can scale off it, and I'll say where that's a guess.
